![]() ![]() Via the head unit, see: Setup menu > Setting 05 - Peukert exponent. In VictronConnect see: Settings > Battery > Peukert exponent. The tail current must be set higher in this case. Some lithium battery chargers stop charging when the current drops below a set threshold. ![]() Via the head unit, see: Setup menu > Setting 03 - Tail current. In VictronConnect see: Settings > Battery > Tail current. See the All features and settings chapter. Further battery monitor configurations are required if your system contains a battery with different chemistry, like lithium, or if other specific system settings are needed. It is now set up for an average system with GEL, AGM or flooded lead-acid batteries. The battery monitor is now ready for use. For details and limitations of automatic voltage detection, see the next chapter ?. Immediately after the completion of the setup wizard, the battery monitor will automatically detect the nominal voltage of the battery system. Press the SETUP, + or – button to end the setup wizard and switch to the normal operating mode. Should a correction need to be made, press SELECT again and repeat the previous steps. Repeat this step until the required battery capacity is displayed. Press SELECT to set the next digit in the same manner. For more information on battery capacity, see the Battery capacity and Peukert exponent chapter. Preferably use the 20-hour (C20) battery capacity rating. Use the + and – buttons to set the first digit of the battery capacity value. The scrolling text will stop, and the factory default battery capacity value (200 Ah) will be shown with the first digit blinking. Press any button to enter the setup wizard. The display shows the scrolling text "battery capacity". State of charge does not increase fast enough or too fast when charging There is a current reading while no current flows Charge and discharge current are inverted Saving, loading and sharing settings in VictronConnect ![]() Accessing settings via the VictronConnect app Connecting to a GX device and the VRM portal Accessing historical data via the head unit Accessing historical data via the VictronConnect app ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |